SLC System, 5/03 RS Programmer Cable, 10Ft., (3M). Catalog No: CP3 Codale Item No: UPC: UNSPSC 06/19/ PM. Access Level. Everyone. CP3/CP3 Cable Pinout. Question. What is the pin out for the CP3/CP3. The KE module is a communication interface module that acts as a bridge between .. The figures below show male connectors, and their pinout locations, for. Allen-Bradley Personal Computer Using a CP3 cable. KE .
|Published (Last):||24 November 2010|
|PDF File Size:||10.32 Mb|
|ePub File Size:||2.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
However, it is possible to configure it in the PLC settings to be, or baud at as well. To exclude a word, precede it with a “-“, as follows: By Bruce Axtell on 20 July, – 9: To search the site, enter your search terms in the box labeled “search the site” and hit Enter.
Scripting must be enabled to use this site.
I now use a Belkin one and it works on high baud rates. The official A-B cable is CP3. Older PLCs, however, tend to use a myriad of different cables and protocols.
I think both ways will work. You must be a Control.
Username Password Remember me on this computer. Please read this important info!!! Select the categories for which you would like to see messages displayed There is one potential pitfall: January 26th, Once you plug in your cable and Windows installs any necessary drivers, it should show up in Device Manager as a COM port.
The CP3 is 1747-cpp3 null modem cable see pic below for pin-out To convert a straight thru RS cable to a null modem cable you need a null-modem adapter Radio Shack should have one if needed.
1747-CP3 – DB9 Male to Right Angle DB9 Female. Allen Bradley Cable. (Custom)
Also see links below for procedure and for other cables in case you don’t have a real serial port and need a USB adapter. Help keep our servers running Last edited by Mickey; January 26th, at All times are GMT If you want happiness for a month- get married.
You are not registered yet. Last edited by Mickey; July 11th, at Hey Mickey, thanks for your help.
Here’s one link http: I had a radioshack piece of junk that could only to Originally Posted by BillRobinson Sydney, Nova Scotia Posts: Post 2 of this thread shows the pin-out but here they are again. Originally Posted by Mickey.
Originally Posted by Mickey I’m no expert on the handshaking pins. This blog post summarizes the different ways that you can connect to these PLCs and some of the pitfalls to look out for.
The two most common ways to connect are DH and DF1. But if you are making your own cable then all you need is pins 2,3 and 5.
A-B CP3 SLC5/03 RS PROGRAMMING CABLE
You can get one at link below. In addition, you will need the female-to-female null modem crossover DB9 serial cable or a straight-through RJ45 ethernet cable, depending on which port you want to connect to.
A tutorial introduction to programming using the QuickBuilder Programming Environment.