Installation instructions • Read online or download PDF • Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual. Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual – Download. Rockwell Automation IF8 Compact IF8 Analog. The Compact I/O modules can be used with a CompactLogix controller, IF4FXOF2F. IF8. IF16C. IF16V. IR6. IT6.

Author: Zulurisar Malkis
Country: Albania
Language: English (Spanish)
Genre: Technology
Published (Last): 14 June 2017
Pages: 469
PDF File Size: 7.5 Mb
ePub File Size: 15.97 Mb
ISBN: 524-3-77277-885-4
Downloads: 19782
Price: Free* [*Free Regsitration Required]
Uploader: Zolodal

Tell us what’s missing.

You can mxnual the bare wire or a spade lug. Your manual failed to upload Host Controller Spacing for single-wide modules 35 mm 1.

What’s missing? Tell us about it.

Use a power supply that matches the input transmitter specifications. The terminals will accept a 6.

Input Data File Word For each input module, slot manal, words in the input data file contain the analog values of the inputs. Wire fragments that fall into a module could cause damage at power up.


Rockwell Automation 1769-IF8 Compact 1769-IF8 Analog Input Module User Manual

Remove the label from the door, mark the identification of each terminal with mankal ink, and slide the label back into the door. The same information applies to all channels.

For More Inform ation Your markings ID tag will be visible when the module door is closed. Route the wire under the terminal pressure plate.

Mounting screws are required on every module.

This lets you individually cancel each low process alarm latch. However, some systems, like the ADN DeviceNet Adapter, also allow the bits to be altered as part of the control program, using communication rungs. Locate holes every Use M4 or 8 panhead screws.

The terminal screws are non-captive. Tell us about it. Don’t see a manual you are looking for?

Rockwell Automation IF8 Compact IF8 Analog Input Module User Manual | Page 10 / 32

Approximate Shipping Weight with carton g 0. Or point us to the URL where the manual is located.


17669-if8 Ensure it is locked firmly in place. Overall hole spacing tolerance: NC Wiring for channels are identical. In that case, graphical screens are provided by the programmer to simplify configuration. Attach an end cap terminator 5 to the last module in the system by using the tongue-and-groove slots as before.

Rockwell Automation

The latches will momentarily open and lock into place. Rockwell Automation Support Rockwell Automation provides technical information on the web to assist you in using our products. Lock the end cap bus terminator 6. Loosen the terminal screws to be wired. Replacing a Single Modu le within a System To allow communication between the controller and module, move the bus lever fully to the left 4 until it clicks. Manua 0 and 1 Configuration Data Channel 0 and 1 configuration data is shown below.