RESISTOFLEX® MEETS CRITICAL STANDARDS. IS ASME B PIPING CODE. IMPORTANT TO YOU? • ASTM F is a listed component standard in. ASTM Fa. Standard Specification for Plastic-Lined Ferrous Metal Pipe, Fittings, and Flanges. standard by ASTM International, 05/01/. plant to facilitate immediate / fast delivery of material. As per ASTM F 3 – 6mm. Varying on sizes. ASTM A, Dimensions to B, ASA
|Published (Last):||23 September 2012|
|PDF File Size:||20.83 Mb|
|ePub File Size:||12.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. This specification covers factory-made plastic-lined ferrous metal pipe, fittings, and flanges for conveying corrosive fluids. Lining material shall be made from a resin that conforms to the requirements of this specification.
ASTM F – 97 Standard Specification for Plastic-Lined Ferrous Metal Pipe, Fittings, and Flanges
r1545 Other requirements include mechanical properties, specific gravity, finish, dimensions, design, working pressure, working temperature, flange construction, venting, workmanship, performance, quality, marking, and packaging.
High-temperature test, low-temperature test, steam-cold water cycling test, vacuum test, hydrostatic pressure test, and electrostatic test shall be done in accordance to the procedures of this specification.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Requirements for materials, workmanship, dimensions, design, fabrication, working pressure and temperatures, test methods, qualification requirements, and markings are included. Refer to the manufacturer’s chemical resistance data for suitability recommendations. Pressure limitations shall be in accordance with ASME B16 Standards, except reduced pressure limitations may be established by the manufacturer, considering both pressure and temperature limitations of the ferrous metal housing and the sealing ability of the liner.
In this specification, propylene plastics cover those materials defined as both polypropylene plastics and propylene plastics in Terminology F End users should consult with manufacturers as to the likely result of using a particular lined piping component at temperatures below the rated minimum.
The temperature limitations are based on noncorrosive test conditions. Use in specific aggressive environments may alter temperature limitations.
In such instances, specific temperature limits shall be established by mutual agreement between the purchaser and the manufacturer. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Standard Specification for Plastic-Lined Ferrous Metal Pipe, Fittings, and Flanges
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Link to Active This link will always route to the current Active version of the standard.